SBAS and NMEA not enabled

SBAS and NMEA aren't enabled on the current T10 tablets. The attached config files will enable both. The steps to use the config file are below.

1. Save the attached file to the T10.

3. Open the ucenter. Go to Receiver> Port and connect to the ublox port.

4. Once you have a connection to the port, go to Tools> GNSS Configuration.

5. Click the browse button and browse to the save file.

6. Click the File>GNSS button to read the file.

7. It should pop up a window reading the text and let if finish loading.

8. Go to Receiver>Port and Disconnect.

Related Articles
NMEA output from Trimble to Collector
The NMEA output from a Trimble R2 and R1 GNSS receivers are the only Trimble receivers compatible with iOS and Android. All GeoExplorer series (Geo 2005/2008/3000/6000/7X) and Pathfinder Pro series (ProXT/XH Pro 6H/6T) units from Trimble can output ...
Creating a new task-enabled layer in ArcGIS Online
Adding Real-time Configurations for TerraFlex Maps in Trimble Connect
The attached document provides directions on creating and sharing real-time configurations for use in TerraFlex.
R1 5.44 firmware
The new Trimble R1 firmware sets NMEA to output automatically. If you connect in GNSS Status and set the NMEA output manually, this will lower the buad rate and may cause your software to operate slower. Best practice would be to download the 5.44 ...

Related Articles